Rust-Oleum 9200 Rust-O-Thane Transparent 5L Kit

Rust-Oleum 9200 Rust-O-Thane in transparent: a two-pack, water-based satin polyurethane supplied as a complete 5 litre kit (4.25 litre base with 0.75 litre activator).

Key features

• Hardwearing two-pack water-based polyurethane with a smooth satin finish
• Automotive-level UV stability; does not yellow
• High abrasion resistance and extremely scratch resistant
• Water-based with low odour (VOC 35 g/l)
• For floors, walls, stairs, wood and metal, and as a topcoat over epoxy and acrylic systems

Where to use it

Inside and outside, over Rust-Oleum epoxy or acrylic coatings (for example 9100, 5401, Pegasol or Pegalink): coated floors, coated walls and primed metal, plus stairs, doors and kitchen walls. It resists solvents, moderate alkalis, weak acids and chemical cleaning. Not recommended for standing water or immersion.

Technical details

• Mixing ratio base : activator 5.66 : 1 by volume (kit supplied matched); induction 5 minutes; pot life 2 hours
• Touch dry 2 hours; handle 4 hours; recoat 24 hours; fully cured 2 days (20°C)
• Theoretical coverage 6.2 m²/litre at 60 µm dry on floors, 9.2 m²/litre at 40 µm on other surfaces (depending on colour)
• Brush, roller (8–12 mm polyamide) or airless, undiluted
• Apply at 5–35°C, humidity below 80%, surface 3°C above dew point
• Heat resistant to 90°C dry (discolouration possible above 65°C)
• Clean up with water and soap before drying; opened activator must be used within 1 week

Preparation

Degrease, sand sound coatings and make a test application to confirm compatibility. Remove poorly adhering coatings and spot-prime with recommended Rust-Oleum or Mathys coatings.

Download the official 9200 Rust-O-Thane technical data sheet (PDF). Read the safety data sheet and the can label before use.