RUSTOLEUM
Rust-Oleum CombiColor Original 7300 Smooth Gloss - Tinted Colours
Rust-Oleum CombiColor Original 7300 Smooth Gloss - Tinted Colours
Enter Colour Required Here We Can Match Any Colour
Couldn't load pickup availability
Rust-Oleum CombiColor Original 7300 Smooth Gloss, tinted to the colour you choose. CombiColor Original is a primer and topcoat in one for metal: a urethane-modified alkyd that dries well even at low temperatures, with rust-inhibitive pigments and no lead or chromate. Apply it straight onto bare or manually de-rusted steel for long-lasting protection with a single product.
Key features
- Primer and topcoat in one, for application onto rust and bare metal
- High coverage: 10.3 m² per litre at 55 µm dry film
- Sag resistant, leaving no brush strokes
- Usable down to 5°C
- gloss finish (95% gloss at 60°)
- Corrosion protection for light industrial environments
Where to use it
Bare, manually de-rusted, or CombiPrimer Anti-Corrosion 3369/3380 primed steel, inside or out. For metal structures in a more aggressive industrial environment, apply CombiPrimer Anti-Corrosion 3369/3380 first. Galvanised, zinc and aluminium surfaces must be primed first with CombiColor Adhesion Primer 3302.
Preparation
Remove oil, grease and other contamination by alkaline or high-pressure (steam) cleaning with a suitable detergent. Remove rust scale, loose mill scale, loose rust and loose coatings by scraping and wire brushing to St 3 (ISO 8501-1), light blast cleaning or sanding, and sand intact coatings to roughen them slightly. The surface must be clean and dry. Stir thoroughly before use.
Application
- Brush: natural-bristle, long-hair brush; thin up to 10% with Rust-Oleum Thinner 7301
- Roller: short-nap polyamide roller (6–12 mm); thin up to 10% with Thinner 7301. Rollering may need 2 coats to reach the recommended film thickness
- Air-atomised spray: thin 10–25% with Thinner 7301; 1.0–1.5 mm tip, 2–4 bar
- Apply at 5–35°C (air, surface and paint), relative humidity below 85%, with the surface at least 3°C above dew point
- Clean equipment with Rust-Oleum Thinner 7301 or Thinner 160
Technical details
- Recommended film: 100 µm wet / 55 µm dry; maximum 75 µm dry (135 µm wet) per coat
- Drying at 20°C: touch dry 2 hours, handle 8 hours, recoat after 16 hours, fully cured 7 days
- Solids by volume 53–57%; density 0.9–1.10 g/cm³
- Heat resistance 90°C dry heat (may discolour at higher temperatures)
- VOC 477 g/l (EU limit, category A/i: 500 g/l)
Choosing your colour
Type the colour you need in the Type Colour Below box above the Add to Basket button: a RAL, BS 4800 or NCS reference, or the colour name. Each tin is tinted to order for you.
- Tinted to order, non-returnable (unless faulty).
- Ordering several tins of one colour? Buy them together and mix (box) the tins before you start for an even colour.
- Colours on screen are a guide only.
Share
